TZR250 3MA
Go to content

The SP swingarm witch I bought didn't come with the chain adjuster blocks.
So had to make something that fits the swingarm

Start point, is making a 20mm hole (not the way it should be done, but it worked)

Second, was to make the block's equally to each other and make the dimensions fit the Swingarm

First fitment, It didn't look that great. Needed to make it less massive

So made some 45 degrees end's and made the axle go deeper inside the block

To give it all a nice Finnish, swapped it over with a flying cutter

Now mounted, its gives a better look. Happy with the results

Back to content