TZR250 3MA
Go to content
Speed limiter in action.

Have made a test setup.
With the pulse generator, I could generate relative good measuring points.
With steps off about 500rpm.
S=safety (speed limiter)
This movie shows the Speed limiter in action.
The pulse generator give a signal round 12.000rpm.

Me giving the speed limiter signal with a metal tap (below in speedlimiter circuit board)
You see clearly that the ypvs motor is closing the pv's a touch
(estimated 30%)
This movie shows the speed limiter in action.

Me making with the pulse generator steps off about 500rpm.
You see when the PV is fully open (at 9720RPM) and RPM is rising after 10.500rpm the ypvs motor Closes the pv's a touch
Back to content